Related papers: Impact of Thermal Behavior on Offset in a High-Q G…
Microelectromechanical systems (MEMS) gyroscopes are widely used, e.g. in modern automotive and consumer applications, and require signal stability and accuracy in rather harsh environmental conditions. In many use cases, device reliability…
Direct electronic structure measurements of a variety of the colossal magnetoresistive oxides show the presence of a pseudogap at the Fermi energy E_F which drastically suppresses the electron spectral function at E_F. The pseudogap is a…
This paper presents a study of accuracy issues in thermal modeling of high power LED modules on system level. Both physical as well as numerical accuracy issues are addressed. Incorrect physical assumptions may result in seemingly correct,…
Defect formation in LiF, which is used as an observation window in ramp and shock experi- ments, has significant effects on its transmission properties. Given the extreme conditions of the experiments it is hard to measure the change in…
This paper shows the CFD investigation of pressure drop and thermal performance of aluminum oxide nano fluid inside square channel inserted a cylinder with and without fin using two-phase method. The constant heat flux on outer wall and…
Silicon-MEMS gyroscope is an important part of MEMS (Micro Electrical Mechanical System). There are some disturb ignored in traditional gyroscope that must be evaluated newly because of its smaller size (reach the level of micron). In these…
We study theoretically the internal thermal noise of a mirror coated on a plano-convex substrate. The comparison with a cylindrical mirror of the same mass shows that the effect on a light beam can be reduced by a factor 10, improving the…
A new set-up to measure acoustic wave velocities through deforming rock samples at high pressures (up to 1000 MPa), temperatures (up to 700$^\circ$C) and differential stress (up to 1500 MPa) has been developed in a recently refurbished gas…
Flow and heat transfer in a compressor rotating disc cavity with axial throughflow is investigated using wall-modelled large-eddy simulations (WMLES). These are compared to measurements from recently published experiments and used to…
We study the effect of random offset charges in the insulator to conductor transition in systems of capacitively coupled grains, as realized in two-dimensional arrays of ultrasmall Josephson junctions. In presence of disorder, the…
Gravimeters fabricated with MEMS suffer from temperature-dependent drifts in their long-term stability. We analyze the thermal contributions to the signal, and we propose three mechanisms to mitigate their effects. The first one uses…
Atomic force microscopy cantilevers are often, intentionally or not, heated at their extremity. We describe a model to compute the resulting temperature field in the cantilever and in the surrounding fluid on a wide temperature range. In…
The temperature dependence of the response of a magnetic system to an applied field can be understood qualitatively by considering variations in the energy surface characterizing the system and estimated quantitatively with rate theory. In…
Graphene oxide (GO) is reduced by Joule heating using in-situ transmission electron microscopy (TEM). The approach allows the simultaneous study of GO conductivity by electrical measurements and of its composition and structural properties…
Precision fiber optic gyroscopes were mounted mechanically de-coupled above spinning rings inside a cryostat. Below a critical temperature (typically <30 K), the gyroscopes measure a significant deviation from their usual offset due to…
Detailed experimental studies of the conductance of mesoscopic GaAs devices in the few-mode regime reveal a novel thermal effect: for temperatures up to at least 10 K the measured gate characteristics, i.e. conductance $G$ versus gate…
Increasing requirements in the sensitivity of interferometric measurements is a common feature of several research fields, from gravitational wave detection to quantum optics. This motivates refined studies of high reflectivity mirrors and…
In-situ transmission electron microscopy (TEM) has become an important technique to study dynamic processes at highest spatial resolution and one branch is the investigation of phenomena related with electrical currents. Here, we present…
We explore the strengths and limitations of using a standard Michelson interferometer to sample line-of-sight-averaged temperature in water via two experimental setups: slow-varying temperature in static fluid and fast temperature…
Refractive optics in astronomical instruments are potentially sensitive to temperature gradients and temperature transients. This sensitivity arises from thermally dependent refractive indices, lens spacings, and lens dimensions. We have…