Related papers: High sensitivity cantilevers for measuring persist…
Superconducting circuits are a promising platform for implementing fault-tolerant quantum computers, quantum limited amplifiers, ultra-low power superconducting electronics, and sensors with ultimate sensitivity. Typically, circuit…
Detection and imaging of an electrically conductive object at a distance can be achieved by inducing eddy currents in it and measuring the associated magnetic field. We have detected low-conductivity objects with an optical magnetometer…
Quantum entanglement has been generated and verified in cold-atom experiments and used to make atom-interferometric measurements below the shot-noise limit. However, current state-of-the-art cold-atom devices exploit separable (i.e.…
Andreev reflection, which corresponds to the tunneling of two electrons from a metallic lead to a superconductor lead as a Cooper pair (or vice versa), can be exploited to measure high frequency noise. A detector is proposed, which consists…
We propose a spintronic strain sensor capable of sensing strain with a sensitivity of 1E-13/sqrt{Hz} at room temperature with an active sensing area of 1 cmE2 and power dissipation of 1 watt. This device measures strain by monitoring the…
Over the last decades, the use of magnetic nanoparticles in research and commercial applications has increased dramatically. However, direct detection of trace quantities remains a challenge in terms of equipment cost, operating conditions…
A novel wireless microstrip-based RF sensor designed for detecting changes in ionic content of water and the addition of solid contaminant objects is proposed and demonstrated. The sensor can be installed on the exterior wall of dielectric…
In multichannel rings, evanescent modes will always co-exist with propagating modes. The evanescent modes can carry a very large diamagnetic persistent current that can oscillate with energy and are very sensitive to impurity scattering.…
Quantum metrology utilizes entanglement for improving the sensitivity of measurements. Up to now the focus has been on the measurement of just one out of two non-commuting observables. Here we demonstrate a laser interferometer that…
We present a novel two-qubit quantum magnetometer Hamiltonian optimized for enhanced sensitivity and noise resilience. Compared to existing models, our formulation offers advantages in accuracy, robustness against noise, and entanglement…
Quantum metrology makes use of coherent superpositions to detect weak signals. While in principle the sensitivity can be improved by increasing the density of sensing particles, in practice this improvement is severely hindered by…
Persistent currents in disordered mesoscopic rings threaded by a magnetic flux are calculated using exact diagonalization methods in the one-dimensional (1D) case and self-consistent Hartree-Fock treatments for two dimensional (2D) systems.…
Fast, high-fidelity measurement is a key ingredient for quantum error correction. Conventional approaches to the measurement of superconducting qubits, involving linear amplification of a microwave probe tone followed by heterodyne…
We demonstrate a proof-of-principle magnetometer that relies on the active oscillation of a cold atom Raman laser to continuously map a field-sensitive atomic phase onto the phase of the radiated light. We demonstrate wideband sensitivity…
A suspended system for measuring the thermal properties of membranes is presented. The sensitive thermal measurement is based on the 3$\omega$ dynamic method coupled to a V$\ddot{o}$lklein geometry. The device obtained using micro-machining…
We present a method of sensing AC magnetic fields. The method is based on the construction of a robust qubit by the application of continuous driving fields. Specifically, magnetic noise and power fluctuations of the driving fields do not…
We calculate persistent current of one-dimensional rings of fermions neglecting the spin degrees of freedom considering only nearest-neighbor Coulomb interactions with different electron fillings in both ordered and disordered cases. We…
In this work we introduce a new method of a ferromagnetic resonance (FMR) detection from thin, nm-size, films. Our setup is based on the commercial piezo-cantilever, used for atomic force microscopy. It has an option to rotate the sample in…
We have realized a microstrip based THz near field cantilever which enables quantitative measurements of the impedance of the probe tip at THz frequencies (0.3 THz). A key feature is the on-chip balanced hybrid coupler which serves as an…
Magnetometry based on diamond nitrogen-vacancy (NV) centers has been extensively studied for applications requiring diverse capabilities, spanning from nanometer spatial resolution to subpicotesla sensitivity. Among various applications,…