Related papers: Polymer and surface roughness effects on the drag …
The flow of fluids in channels, pipes or ducts, as in any other wall-bounded flow (like water along the hulls of ships or air on airplanes) is hindered by a drag, which increases many-folds when the fluid flow turns from laminar to…
An addition of polymers can significantly reduce drag in wall-bounded turbulent flows, such as pipes or channels. This phenomenon is accompanied by a noticeable modification of the mean velocity profile. Starting from the premise that…
A small amount of polymer additives can cause substantial reduction in the energy dissipation and friction loss of turbulent flow. The problem of polymer-induced drag reduction has attracted continuous attention over the seven decades since…
The existence of drag reduction by polymer additives, well established for wall-bounded turbulent flows, is controversial in homogeneous, isotropic turbulence. To settle this controversy we carry out a high-resolution direct numerical…
When injected through a contraction, high molecular weight polymer solutions exhibit a sharp increase of apparent viscosity which originates from stretching polymer chains above a critical extension rate. This chain stretching can also…
We present the most extensive direct numerical simulations, attempted so far, of statistically steady, homogeneous, isotropic turbulence in two-dimensional fluid films with air-drag-induced friction and with polymer additives. Our study…
We report measurements of turbulent drag reduction of two different polyelectrolyte solutions: DNA and hydrolyzed Polyacrylamide. Changing the salt concentration in the solutions allows us to change the flexibility of the polymer chains.…
The phenomenon of drag reduction by polymer additives had been studied in simulations on the basis of non-Newtonian fluid mechanical models that take into account the field of polymer extension (conformation tensor) and its interaction with…
Injection of dilute polymer in a turbulent flow suppresses frictional drag. This challenging and technologically important problem remains primarily unresolved due to the complex nature of the flow. An important factor in the drag reduction…
The addition of minute amounts of chemically inert polyacrylamide polymer to liquids results in large instabilities under steady electro-osmotic pumping through 2:1 constrictions, demonstrating that laminar flow conditions can be broken in…
Velocity relaxation of a spherically symmetric polymer, immersed in a viscous incompressible fluid, and after a sudden small impulse or a sudden twist from a state of rest, is studied on the basis of the linearized Navier-Stokes equations…
Motivated by the large effect of turbulent drag reduction by minute concentrations of polymers we study the effects of a weakly space-dependent viscosity on the stability of hydrodynamic flows. In a recent Letter [Phys. Rev. Lett. {\bf 87},…
We study the effects of polymer additives on pseudoturbulence induced by a swarm of bubbles rising in a quiescent fluid. We find that, beyond a critical polymer concentration, the energy spectra of velocity fluctuations in bubble-induced…
We present an experimental study on the drag reduction by polymers in Taylor-Couette turbulence at Reynolds numbers ($Re$) ranging from $4\times 10^3$ to $2.5\times 10^4$. In this $Re$ regime, the Taylor vortex is present and accounts for…
The influence of an external flow on the relaxation dynamics of a single polymer is investigated theoretically and numerically. We show that a pronounced dynamical slowdown occurs in the vicinity of the coil-stretch transition, especially…
Polymer additives can substantially reduce the drag of turbulent flows and the upper limit, the so called "maximum drag reduction" (MDR) asymptote is universal, i.e. independent of the type of polymer and solvent used. Until recently, the…
We report on the modification of drag by neutrally buoyant spherical particles in highly turbulent Taylor-Couette flow. These particles can be used to disentangle the effects of size, deformability, and volume fraction on the drag, when…
We present results from a systematic numerical study of decaying turbulence in a dilute polymer solution by using a shell-model version of the FENE-P equations. Our study leads to an appealing definition of drag reduction for the case of…
Drag reduction by polymers in turbulent flows raises an apparent contradiction: the stretching of the polymers must increase the viscosity, so why is the drag reduced? A recent theory proposed that drag reduction in agreement with…
Creeping flow of polymeric fluid without inertia exhibits elastic instabilities and elastic turbulence accompanied by drag enhancement due to elastic stress produced by flow-stretched polymers. However, in inertia-dominated flow at high…