Related papers: Three-port beam splitters-combiners for interferom…
We report a theoretical and experimental investigation of fiber Fabry-Perot cavities aimed at enhancing Kerr frequency comb generation. The modulation instability (MI) power threshold is derived from the linear stability analysis of a…
The quantum entanglement between two qubits is crucial for applications in the quantum communication. After the entanglement of photons was experimentally realized, much effort has been taken to exploit the entangled electrons in…
We demonstrate two approaches for unbalanced interferometers as time-bin qubit analyzers for quantum communication, robust against mode distortions and polarization effects as expected from free-space quantum communication systems including…
In this work, a general theoretical framework is presented to explain the formation of the phase signal in an X-ray microscope integrated with a grating interferometer, which simultaneously enables the high spatial resolution imaging and…
We study the quantum interference between different weak signals in a three-port optomechanical system, which is achieved by coupling three cavity modes to the same mechanical mode. If one cavity serves as a control port and is perturbed…
Predictions and measurements of a multimode waveguide interferometer operating in a fibre coupled, ``dual-mode'' regime are reported. With a 1.32 micrometer source, a complete switching cycle of the output beam is produced by a 10.0…
It is usually considered that the spectrum of an optical cavity coupled to an atomic medium does not exhibit a normal-mode splitting unless the system satisfies the strong coupling condition, meaning the Rabi frequency of the coherent…
In ground-based astronomy, the ability to couple light into single-mode fibers (SMFs) is limited by atmospheric turbulence, which prohibits the use of many astrophotonic instruments. We propose a silicon-on-insulator photonic chip capable…
We characterize a Fabry-Perot microwave cavity designed for trapping atoms and molecules at the antinode of a microwave field. The cavity is fed from a waveguide through a small coupling hole. Focussing on the compact resonant modes of the…
We demonstrate micromechanical reflectors with a reflectivity as large as 99.4% and a mechanical quality factor Q as large as 7.8*10^5 for optomechanical applications. The reflectors are silicon nitride membranes patterned with…
We show that any multi-qudit entanglement witness leads to a non-separability indicator for quantum optical fields, which involves intensity correlations. We get, e.g., necessary and sufficient conditions for intensity or intensity-rate…
A key factor in any RF system is the mechanism for coupling the RF power from an amplifier into an accelerating cavity. Any tranmission line will experience reflections if there is a mismatch in the impedance between the line and its load.…
A new type of an optical interferometer is discussed the phase difference between the interfering beams in which is substantially wavelength dependent. It is shown that the function measured with this device is an integral transform of the…
We study the optomechanical coupling of a single-layer graphene with a high-Q Fabry-Perot microcavity in the membrane-in-the-middle configuration. In ordinary dissipative coupling systems, mechanical oscillators modulate the loss associated…
In this study, we theoretically and numerically investigate the resonant modes and reflectance of an optical grating consisting of a wavy dielectric slab by applying the spectral element method. The presence of the wavy shape transforms the…
We study a nonlinear interferometer consisting of two consecutive parametric amplifiers, where all three optical fields (pump, signal and idler) are treated quantum mechanically, allowing for pump depletion and other quantum phenomena. The…
We report the design, fabrication in a commercial foundry, and experimental results of high-efficiency, normal incidence grating couplers for silicon photonics. We observe a maximum coupling efficiency of 85.4% (-0.69 dB) with a 1 dB…
We describe the fundamental features of an interferometer for guided matter waves based on Y-beam splitters and show that, in a quasi two-dimensional regime, such a device exhibits high contrast fringes even in a multi mode regime and fed…
In most optomechanical systems a movable mirror is a part of an optical cavity, and its oscillation modulates either the resonance frequency of the cavity, or its coupling to the environment. There exists the third option -- which we call a…
Optical cavities have found widespread use in interfacing to quantum emitters. Concerns about backreflection and resulting loss, however, have largely prevented the placement of optics such as lenses or modulators within high-finesse…