Related papers: Roughness induced boundary slip in microchannel fl…
We report an experimental and numerical study of turbulent fluid motion in a free surface. The flow is realized experimentally on the surface of a tank filled with water stirred by a vertically oscillating grid positioned well below the…
A combination of methods originating from non-stationary timeseries analysis is applied to two datasets of near surface turbulence in order to gain insights on the non-stationary enhancement mechanism of intermittent turbulence in the…
The lattice Boltzmann (LB) method has gained much success in a variety of fields involving fluid flow and/or heat transfer. In this method, the bounce-back scheme is a popular boundary scheme for treating nonslip boundaries. However, this…
Direct Numerical Simulations (DNS) of turbulent channel flow at a shear Reynolds number of $Re_{*}=360$ for Newtonian and Herschel-Bulkley fluids in smooth and rough channels has been performed. The rough surface was made of irregular…
Wall modelling in large-eddy simulation (LES) is necessary to overcome the prohibitive near-wall resolution requirements in high-Reynolds-number turbulent flows. Most existing wall models rely on assumptions about the state of the boundary…
Turbulent flow over a surface with streamwise-elongated rough and smooth stripes is studied by means of direct numerical simulation (DNS) in a periodic plane open channel with fully resolved roughness. The goal is to understand how the mean…
The pseudopotential multiphase lattice Boltzmann (LB) model is a very popular model in the LB community for simulating multiphase flows. When the multiphase modeling involves a solid boundary, a numerical scheme is required to simulate the…
We study experimentally the motion of non-deformable microbeads in a linear shear flow close to a wall bearing a thin and soft polymer layer. Combining microfluidics and 3D optical tracking, we demonstrate that the steady-state bead/surface…
It is commonly assumed that fluid cannot slip along a solid surface. The experimental evidence generally supports this assumption. We demonstrate that when the change of the relative velocity of a fluid and a solid wall is sufficiently…
Computational modeling and simulation of fluid-structure interactions constitute a fundamental cornerstone for advancing aerospace engineering endeavors. This paper addresses the notion and implementation of the immersed boundary method for…
This paper reports turbulent boundary layer measurements made over open-cell reticulated foams with varying pore size and thickness, but constant porosity ($\epsilon \approx 0.97$). The foams were flush-mounted into a cutout on a flat…
Zhu & Granick [Phys. Rev. Lett. 87, 096105 (2001)] have recently experimentally established existence of a boundary slip in a Newtonian liquid. They reported typical values of the slip length of the order of few micro-meters. In this light,…
A lattice Boltzmann scheme able to model the hydrodynamics of phase separation and two-phase flow is described. Thermodynamic consistency is ensured by introducing a non-ideal pressure tensor directly into the collision operator. We also…
Mean-field coupled lattice maps are used to approximate the physics of driven threshold systems with long range interactions. However, they are incapable of modeling specific features of the dynamic instability responsible for generating…
In the last decade, progresses in additive manufacturing (AM) have paved the way for optimized heat exchangers, whose disruptive design will depend on predictive numerical simulations. Typical AM rough surfaces show limited resemblance to…
Surface roughness significantly impacts transition to turbulence, especially over high-speed, blunt geometries where surface ablation is necessary to mitigate heat loads during atmospheric entry. Inspired by sand-grain roughness experiments…
The effect of wall slip on the apparent flow curves of viscoplastic materials obtained using torsional parallel plate rheometers is analysed by considering Herschel-Bulkley fluids and assuming that slip occurs above a critical wall shear…
Using a dynamic Surface Force Apparatus, we demonstrate that the notion of slip length used to describe the boundary flow of simple liquids, is not appropriate for viscoelastic liquids. Rather, the appropriate description lies in the…
The lattice Boltzmann method has become a widely adopted approach in computational fluid dynamics, offering unique advantages in mesoscopic kinetic modeling, intrinsic parallelism, and simple treatment of boundary conditions. However, its…
We study the deformation and dynamics of droplets in time-dependent flows using 3D numerical simulations of two immiscible fluids based on the lattice Boltzmann model (LBM). Analytical models are available in the literature, which assume…