Today, hot embossing and injection molding belong to the established plastic molding processes in microengineering. Based on experimental findings, a variety of microstructures have been replicated so far using the processes. However, with increasing requirements regarding the embossing surface and the simultaneous decrease of the structure size down into the nanorange, increasing know-how is needed to adapt hot embossing to industrial standards. To reach this objective, a German-Canadian cooperation project has been launched to study hot embossing theoretically by a process simulation and experimentally. The present publication shall report about the first results of the simulation - the modeling and simulation of large area replication based on an eight inch microstructured mold.
@article{arxiv.0802.3042,
title = {Modeling of large area hot embossing},
author = {M. Worgull and K. K. Kabanemi and J. -P. Marcotte and J. -F. Hétu and M. Heckele},
journal= {arXiv preprint arXiv:0802.3042},
year = {2008}
}
Comments
Submitted on behalf of EDA Publishing Association (http://irevues.inist.fr/EDA-Publishing)