A CubeSat Electronics System for Dual-Satellite Coordinated Soft X-Ray Polarimetry

Addressing the unique requirements for a wide field of view and rapid response in soft X-ray polarization measurements of transient sources such as gamma-ray bursts, this paper proposes the design of a high-reliability CubeSat payload electronics system for dual-satellite cooperative observation. The system employs a Gas Microchannel Pixel Detector (GMPD) and a Topmetal-L sensor as its core components, forming a highly integrated, low-noise payload hardware platform. It achieves a field of view of 90$^\circ$ $\times$ 90$^\circ$, a sensitive area of 3.69 cm$^{2}$, and a power consumption of less than 6 W, operating within an energy range of 2--10 keV. The system incorporates autonomous high-voltage (HV) ramp-up/ramp-down control and a dual-protection mechanism based on count rate and discharge events, enabling in-orbit responses to risks such as the South Atlantic Anomaly and solar particle events. It also supports single-event upset detection and recovery, as well as in-orbit firmware upgrades. The communication interface adopts a redundant primary/backup Controller Area Network (CAN) bus design, with measured channel switching times of less than 100 ms, meeting the demands for real-time command interaction in dual-satellite coordination. By utilizing a large-array pixel sensor with region-of-interest readout and integrating an in-orbit track compression algorithm, the system significantly reduces data storage and downlink transmission resource burdens. Ground tests demonstrate an equivalent noise charge of 22.35 e$^{-}$, HV monitoring linearity better than $\pm$0.5\%, and an output range extending to -5 kV. Thermal vacuum cycling tests show no performance degradation after five cycles between -5 $^\circ$C and 40 $^\circ$C. This work demonstrates the system's capability for autonomous observation, intelligent coordination, and reliable operation in complex space environments.